Pay in 4 interest-free payments of $5.88 Learn more
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 7 - Aug 12
Pay in 4 interest-free payments of $5.88 Learn more
Ships within 48 hours · Estimated delivery Aug 7 - Aug 12
In Stock Retail: $79.99 $69.99 View Add Item# 98140 Pizza night just leveled up
Bass in these locations will display normal behavior

When to Replace Fishing Line Replace or cut back the line when you notice: Fraying or fuzzy sections Flat spots or severe coils Discoloration from heavy use Repeated unexplained knot failures Abrasion after fishing around rocks, docks, shells, or wood Reduced casting performance that does not improve after removing twisted line Fishing Safety and Responsible Use A correctly assembled fishing rod can still cause injury when used carelessly

I had no backlash once I dialed in the spool tension for each lure

Drift the shaft sleeve retaining pin out to the right, push it to the right only, the pin it spined on one side and will not go the other way The bearing retaining plate comes off next, these screws were a little soft be careful With the retaining plate off out comes the bearing, the brass shaft centering bushing, the brass spacer, and then the aluminum spacer Next remove the three screws holding the side plate noting the bottom screw is longer than the other two, at least there was grease inside the gear housing, remove the last screw and remove the shaft retaining plate The handle shaft pulls out, and remove the brass shaft bushing, the anti-reverse dog and anti-reverse selector come out, make not of the direction of the anti-reverse dog and the selector switch spring is tight in the hole, be carful you don't bend it Here we are all torn down, except the bail mechanism Everything goes back together in the reverse order with no surprises, but lots of grease The shaft bearing was unsealed from the factory so it cleaned up real easy and was hand packed with grease, I'm more worried about corrosion than feather light spinning All done and back together, no real surprises except the sleeve pin, which drives only one way, was kinda hard to hold the reel, drift and hammer...

And let me tell you, you talk about close quarters battles
